Verifying radio system on MultiWiiConf application

Once everything is connected between your receiver and your MultiWii flight controller, you can actually see how it works live on the MultiWiiConf application if you power on you FlySky controller ! 😃

1. Connect your MultiWii to the computer via the FTDI and USB cable as when you uploaded the program on it previously.
2. Open MultiWiiConf app
3. Click on your port (COM3) for me. It supposed to turn from red to green.
4. Click on Read, then Start.

Now we will make the SWA (Switch A) on your FlySky controller to arm the motors when you push it down.

This will make them turn at low speed and will not elevate your drone from the ground.

So, to do this you only need to Click on the Square in Aux1 in High column.

This activate arming when aux1 is at high position. (SWA down)

Dont forget to click on Write to save the changes!

You can also test your channels to see how your motors and our throttle, roll, pitch and yaw reacts.

Dont forget also to arm your motors because your controller wont do anything if you dont.